Instructions for Use

Arctic Butterfly®SL700

WARNING: Do Not Spin Device While Brush is on Camera's Sensor

Read complete instructions below before using your spinning device

•1  Requires 1 "AAA" batteries . Use high quality batteries for best performance. Remove the batteries before traveling on an airplane.

•2  Do not use on camera chamber or parts other than sensor, otherwise you will smear the sensor.

•3  Wash inside the cap occasionally with mild soap or in case of a smear.

•4  When removing the cap, do not pull straight off. Instead, "unscrew the cap following the arrows direction then pull"

•5  Turn the device on and spin the brush 3 times for 5 seconds each time. This will enhance the fiber charges and dislodge any particles within the fibers via centripetal force.

•6  Take the Arctic Butterfly® - SL 700 and gently brush across your sensor ONCE. Do not spin the brush while on sensor! Keep your fingers away from the power button on the device while cleaning the sensor to prevent accidental spinning.

•7  Release the camera shutter and proceed with checking the image for evidence of dust particles.

•8  Repeat steps 5 through 7 if necessary.

•9  Re-capping the SL 700-brush head: While rotating the SL700 body, Insert the Brush head into the Cap until the Brush fibers are completely inserted in one direction.

•  It is recommended to clean the brush fibers frequently with isopropyl alcohol (90% -99%) or VisibleDust Brush Wash TabletsT. This should specially be done if the fibers have been in contact with any oil or lubricant. To remove the smear from the sensor, it is recommended that VisibleDust Ultra MXD-100T (green) swabs and Smear AwayT be used to remove the stain. VDust PlusT can also be used for lighter stains.